DAVIS FMS 3.9.3 DriveRight (8186) - Manual (Page 270)

DriveRight FMS User's manual
 The Base Station should be mounted in a high location with its antenna pointing straight
up.
 The Base Station should be mounted away from any other radio transmitters or
microwave ovens.
Guidelines for Extending Communication Range
 Install more than one Base Station to cover a wider area.
 Due to the limited USB cable length, use a 3rd party device to extend distance between
the Base Station and the computer. Refer to the Base Station Installation Manual for
more information.
 Using non-metallic and weather-proof housing in which to store the Base Station(s)
outside.
 Place the Base Station antenna outside where it is visible to the vehicles and use a short
antenna connection cable.
Back to Troubleshooting Menu
Home | Getting Started | Quick Reference | Menu Commands | Troubleshooting
SmartCard Desktop Reader Device Communication
Problems
Installing Drivers for the SmartCard Desktop Reader
The DriveRight SmartCard Desktop Reader (# 8108) works with the DriveRight SmartCard
System to upload data from a DriveRight 600 or 600
E to a computer running DriveRight FMS
version 3.3 or later. The SmartCard Desktop Reader connects to a computer via a USB port.
USB drivers must be installed for the SmartCard Desktop Reader to properly communicate with
DriveRight FMS. This can be done during DriveRight FMS installation or at any time a SmartCard
Desktop Reader is present for set up. A SmartCard Desktop Reader must be available, so it can
be configured during driver installation.
Note: The following installation was completed in a Windows XP operating system. The process
may vary depending on your operating system.
1. Navigate to the DriveRight directory via MicroSoft Windows Explorer or some other
means. A list of subfolders displays.
2. Select SmartCard USB Drivers. Double-click ACS Setup.exe The Installation Wizard
starts.
258