DAVIS FMS 3.9.3 DriveRight (8186) - Manual (Page 194)

DriveRight FMS User's manual
configured for use with your wireless fleet.
6. Click OK to exit the dialog box.
Once the Wireless On-Board Module has been added to the FMS database, it can be installed in
its assigned vehicle or any vehicle in your fleet if you selected Automatic in the Vehicle ID/Lic
Plate drop-down list box. See the GPS/Wireless System Installation Manual for more
information on its installation and proper usage.
Note: The Wireless On-Board Module should only be installed to its assigned vehicle unless
Automatic is selected when adding the module.
Back to Wireless Menu
Home | Getting Started | Quick Reference | Menu Commands | Troubleshooting
Scan Wireless On-Board Modules
The Scan Wireless On-Board Modules dialog box uses the Base Station(s) to scan all of the
Wireless On-Board Modules in the current location and displays the wireless communication
status of each Wireless On-Board Module.
Note: At the top of each hour, the Wireless On-Board Module is turned off by the DriveRight or
Carchip device for up to five minutes. This is done to allow the DriveRight or CarChip to turn on
the GPS module to refresh the satellite position periodically. This occurs even without a GPS
module being physically connected to your DriveRight or Carchip device. FMS will not be able to
communicate with the Wireless On-Board Module(s) during this time.
1. Select Scan Wireless On-Board Modules from the Wireless Menu. The Scan Wireless
On-Board Modules displays a list of all the Wireless On-Board Modules in your
database associated with the currently selected location.
182