Videotec ULISSE COMPACT - Manual (Page 13)

Instruc
tions manual - English - EN
13 MNVCUCZ_1351_EN
6.4 Preparatory work before
installation
6.4.1 Attaching the support
There are two kinds of support, choose the most
suitable one for your installation and follow all the
instructions given in this section.
The device should be assembled vertically.
Any other position could impair the
performance of the appliance. Do not
attach the device upside down.
Take special care when attaching and
fastening down the apparatus. If it is to be
attached to a concrete surface you must
use dowel pins with a traction torque rating
of at least 300dN each. For a metal surface
use screws with a diameter of at least 8mm
and of an appropriate length. The clamping
system must be able to support at least 4
times the weight of the entire equipment,
including P&T, lenses and camera.
6.4.1.1 Fixing with bracket (optional)
The bracket is drilled to make it easy the connection
cables through it.
110
Ø 9
150
Fig. 4
6.4.1.2 Attachment with a pole support
(optional)
The column support allows the internal passage of
the connection cables.
Ш 101.6
Ш 7
Fig. 5
6.4.2 Cables management
The connection cables should not be
accessible from the outside. It is necessary
to fasten the cables securely to the column
in order to prevent excessive weight pulling
them out accidentaly.
You must use cables suited to the type of
installation.
Insert the cables into the support so that they
protrude by about 50cm.
50cm 50cm
Fig. 6