Videotec ULISSE COMPACT - Manual (Page 14)

EN - English - I
nstruc
tions manual
14 MNVCUCZ_1351_EN
7 Assembling and installing
The assembly and installation must be
performed only by skilled personnel.
This is a Class A product. In a domestic
environment this product may cause radio
interference. In this case the user may be
required to take adequate measures.
7.1 Installation
Never, under any circumstances, make
any changes or connections that are not
shown in this handbook. Failure to follow
the connection instructions that are given
in the handbook may create serious safety
hazards for people and for the installation.
Do not change the wiring in the product
as it is supplied to you. Failure to follow
this instruction may create serious safety
hazards for people and for the installation,
and will also invalidate the guarantee.
Keep a connection diagram for future
reference.
7.1.1 Connecting the cables to the base
Insert the cables into the cable glands and, holding
the base at about 20cm from the support, lock
the cable glands with a torque wrench setting of
5Nm. The cable glands are suitable for cables with
diameters of between 5 and 10mm.
Fig. 7
7.1.2 Fixing the base to the support
Use the screws and the washers supplied
with the base.
After having positioned gasket (01), fasten base (02)
on support (03) using screws (04), toothed spring
washers (05) and the flat washers (06). Insert the
screw-sealing OR (07).
01
06
07
05
02
03
04
Fig. 8
03
01
07
02
06
05
04
Fig. 9