Acer Altos G901 - Manual (Page 102)

3 Hardware configuration 86
Removing and installing a fan module
To remove a fan module
1 Remove the front access panel (refer to page 46).
2 Grasp the fan module and pull it straight out of the foam baffle.
To install a fan module
Note: If you are replacing a failed fan module, wait for the fan
status LED to turn off. Generally, this will take less than ten
seconds.
1 Remove the front access panel (refer to page 46).
2 Place the fan module into the empty slot of the fan assembly so
that the fan connector mates with the connector on the fan board.
3 Press down firmly to seat the fan module fully into the connector.
4 Check the fan status LED for the replacement fan.
If the installation was successful, the indicator will not be lit.
5 Reinstall the front access panel (refer to page 46).
Figure 45 - Removing and installing a fan module
BB!H:11!vh!.!FO/cppl!!Qbhf!97!!Gsjebz-!Kbovbsz!28-!3114!!8;24!QN