Acer Altos G901 - Manual (Page 123)

107
Hot-plug indicator board
Replacing the hot-plug indicator board
1 Remove the rear access panel (refer to page 44).
2 Disconnect the ribbon cable from the end of the hot-plug
indicator board.
3 Remove the two plastic rivets that secure the board to the
electronics bay (Figure 55, C).
4 The end of the board where the cable attaches is inserted into a
notch in the chassis. Tilt out the free end of the board and lift the
board out of the notched bracket in the back of the electronics
bay. Two plastic rivet inserts remain in the mounting holes in the
chassis.
Label Description
A Ribbon cable
Figure 55 - Removing the hot-plug indicator board
BB!H:11!vh!.!FO/cppl!!Qbhf!218!!Gsjebz-!Kbovbsz!28-!3114!!8;24!QN