Acer Altos G901 - Manual (Page 194)

Appendix B: System management 178
To set up LAN alerts
To set up the server to send alerts over the LAN:
1 Configure the remote system to receive alerts.
For more information, see the documentation for ASMe.
2 From the SSU Main window, choose Platform Event Manager
(PEM).
3 In the PEM window, click Configure LAN.
4 Select the Enable LAN Alerts check box.
5 (Optional) In the SNMP Community String box, enter a string for
the community field in the Header section of the SNMP trap sent
for an alert. The string must be from 5 to 16 characters. The
default string is public.
6 In the IP Setup box, choose either:
7 If you chose Static IP Setup in the previous step, fill in the IP
addressing boxes:
8 In the Alert IP Address box, fill in the IP address of the system you
want to receive alerts from this server.
• DHCP The IP address for the server is automatically
assigned by the DHCP (dynamic host control
protocol) server on the network. The Host,
Gateway, and Subnet Mask boxes in the dialog are
ignored.
• Static Assign the IP address for the server using the Host,
Gateway, and Subnet Mask boxes in the dialog.
• Host IP
Address The IP address of this server.
• Gateway IP
Address The IP address of the router for this server.
• Subnet
Mask The IP address for the server's subnet. The
server uses this to decide if the alert destination
is on the same subnet.
BB!H:11!vh!.!FO/cppl!!Qbhf!289!!Gsjebz-!Kbovbsz!28-!3114!!8;24!QN