Installing and removing a hot-plug pci, Add-in board – Acer Altos G901 User Manual
Page 85
Advertising
69
Installing and removing a hot-plug PCI
add-in board
To install a hot-plug PCI add-in board
1
Remove the rear access panel (refer to page 44).
2
If the LED for the slot indicates that power to the slot is on, turn it
off by using the PCI hot-plug application software on your system.
The LED adjacent to the slot should now be off.
For more information, refer to “Operating system support for hot-
plug add-in boards” on page 68.
3
Open the latches on the front and rear retention mechanisms
(Figure 34, A and B).
4
If necessary, remove and save the expansion slot cover.
Figure 33 - Hot-plug PCI add-in board status indicators
BB!H:11!vh!.!FO/cppl!!Qbhf!7:!!Gsjebz-!Kbovbsz!28-!3114!!8;24!QN
Advertising