Acer Altos G901 User Manual
Page 72
3 Hardware configuration
56
For a diagram showing labeled connectors, refer to “Mainboard
layout” on page 13.
6
Remove all cables from the cable retention clip on the front of the
electronics bay.
7
A plastic retention mechanism for the PCI add-in cards is fastened
to the front of the electronics bay by three clips (Figure 22, A).
Release each clip by pressing down on the tab and remove the
retention mechanism.
8
Remove the plastic protective overlay covering the PCI area of the
mainboard as follows:
a
Unscrew the captive screw holding the overlay in place
(Figure 22, D).
b
Near the middle of the mainboard, lift the edge of the overlay
until it is clear of the connectors on the board (Figure 22, B).
c
Slide the overlay toward the front of the electronics bay and
unhook it from the two tabs (Figure 22, C).
d
Remove the overlay.
Figure 22 - Removing the front retention mechanism
BB!H:11!vh!.!FO/cppl!!Qbhf!67!!Gsjebz-!Kbovbsz!28-!3114!!8;24!QN