AT&T DEFINITY 555-230-223 - Manual (Page 153)

Appendix E: Sample Customer Configurations
C. Access the Add Host screen again and do the same for
clients 2 and 3 (C2 and C3).
D. You will be on the Local Host Table screen when done. Exit
the screen to return to the TCP/IP Administration Main
Menu.
3. Administer the brouter as follows. On the Main Menu, select
Brouter Administration.
A. Delete the default entry.
B. Press ADD to access the Add Client Link screen. Add an
entry for client 1 on the appropriate port and client link.
C. Access the Add Client Link screen again and do the same
for clients 2 and 3 (C2 and C3).
D. You will be on the Brouter Administration screen when done.
Exit the screen to return to the Main Menu.
4. Reboot the system as follows. On the Main Menu, select
Maintenance. Then select Reset System. When the Reset System
screen appears, select Reboot System.
5. After the reboot, from the Main Menu, choose TCP/IP
Administration. Next choose Network Routing Information, and then
choose Network Routing Daemon.
— Turn the routing daemon on if there is a router on the same
network as
lgateserver, which is broadcasting routes to all
networks where clients reside.
— Turn the routing daemon off if there is no router or if manual
routes are preferred.
6. If the Network Routing Daemon is on, press CANCEL to exit from
the screen. Exit twice more to return to the Main Menu.
If the Network Routing Daemon is off, do the following:
A. Administer the default gateway. Press CANCEL on the
Network Routing Daemon screen to access the Network
Routing Information Main Menu. Select Default Gateway.
On this screen, enter the IP address of the default gateway
(for this example, enter
135.20.1.100 ) and press
ENTER . The Network Routing Information Main Menu
reappears.
B. Select Network Routing Table and then press ADD to
access the Add Routes screen. Administer gateway 2 on
this screen.
E-6 Issue 1 January 1996