AT&T DEFINITY 555-230-223 - Manual (Page 43)

Installation
b. Plug the cable from the ADU into a telephone outlet.
2. In the terminal room, connect the Z3A-1 ADU to the terminal.
a. If you are installing a new terminal, unpack it according to the
instructions supplied with the terminal.
b. Place the terminal on a suitable table and connect the keyboard.
c. Attach the Z3A-1 ADU (male) to a serial RS-232 port on the
terminal (the DTE port on a 715 BCT).
NOTE:
If you connect the ADU to the DCE port on a 715 BCT, you
must also connect a null modem cable between the ADU and
the 715 BCT.
d. Plug one end of the D8AM crossover cord into the connector
labeled Wall Jack on the ADU, and plug the other end of the D8AM
cord into a telephone outlet.
e. Connect the 2012D ADU Power Supply to the ADU. (The power
supply can be connected to either ADU.)
Attach either the 400B2 or 248B adapter to the ADU.
Plug the power supply into the adapter.
Plug the power cord on the power supply into a wall outlet.
f. Power on the terminal.
g. Set the terminal options. Refer to Appendix B, ‘‘Supported
Terminals and Modems,’’ for a complete list of option settings for all
supported terminals.
If the terminal is installed correctly (and the DEFINITY LAN
Gateway system is in either OS, AINIT, or ASAI state), the screen
displays the login prompt.
If the terminal does not display the login prompt when the
DEFINITY LAN Gateway system is in one of the above states, try
pressing the
Return key a few times. If the login prompt still does
not appear, write down the state displayed on the LCD then see the
troubleshooting procedure for terminal connections in Appendix D.
Task 7D: Install a Terminal via 7400A Data Sets
This task describes how to connect a terminal via 7400A Data Sets to
Admin/Port B of the MFB. (This task can also be used for remote connection to
Main/Port A.)
Refer to Figure 2-12, Connecting a Terminal to the MFB via 7400 Data Sets,
when performing this task.
2-24 Issue 1 January 1996