Sony CCD-TRV608 - Manual (Page 47)

2-5-3 Sound Recording Mode
Troubleshooting
Sound files were created, but cannot be played.
Check the speaker power and volume.
Note that the ImageMixer volume control
works independently of the volume control on
the speakers.
In Windows, right click the speaker icon on the task bar and select 'Open Volume
Controls.' If 'Line In' is muted or if the volume is too low, adjust accordingly and
record again.
In Macintosh, open [Apple] menu>[Control Panels]>[Sound], to set the recording
sound level.
The method for adjusting the volume may be different depending on your
computer's configurations, in which case we recommend that you consult the
manufacturer's technical support center.
Recorded analog sound files contain noise and jump.
Confirm that the CD recording volume is suitable.
Refer to ' Sound files were created, but cannot be played ' above.
Also note that we do not recommend that you perform other tasks on your
computer while recording is taking place.
Recorded analog sound files jump.
Your computer hardware may be close to the minimum specifications required to
run ImageMixer. Close all other applications before starting ImageMixer and try
again. (When the CPU and HDD are not being used to run programs other than
ImageMixer, system resources should not become depleted.
Due to the possibility of noise, etc., we do not recommend recording
sounds with internal microphones.
Copyright © 2001 PIXELA Corp. All rights reserved.