Commissioning, English 9 – AC International Lenze SV01B User Manual
Page 20
ENGLISH
9
Commissioning
Code
Possible Settings
IMPORTANT
No.
Name
Default Selection
Note
• When input is activated, settings ...7 override P0
• When TB-A...TB-C are configured for Auto References other than MOP, TB-C overrides
TB-B, and TB-B overrides TB-A. Any other Auto Reference will have priority over MOP.
• Settings 0...4 are only valid in Terminal Strip mode (P00 = , 4, 5)
• If Start/Run/Jog Forward and Start/Run/Jog Reverse are both activated, drive will STOP
• If Jog input is activated while the drive is running, the drive will enter Jog mode; when Jog input is
deactivated, drive will STOP
•
An
fault will occur if the Assertion Level switch (ALsw) position does not match the
P20 setting and any of the digital inputs (P2...P2) are set to a value other than 0.
• An
fault will occur under the following conditions:
- TB-A...TB-C settings are duplicated (each setting, except 0 and , can only be used once)
- One input is set to “MOP Up” and another is not set to “MOP Down”, or vice-versa.
- One input is set to 0 and another input is set to …4.
- One input is set to or 2 and another input is set for or 4.
• Typical control circuits are shown below:
- If any input is set to 0, 2 or 4, P2 must be set to for Reverse action to function.
Run / Stop
with Direction
P2 = 0
Start Forward /
Start Reverse
P2 = , P22 = 2
Run Forward /
Run Reverse
P2 = , P22 = 4
1
4
13A
FWD
REV
STOP
RUN
1
4
13A 13B
RUN
REV
RUN
FWD
FWD
REV
STOP
1
4 13A 13B
Acceleration
Time 2
20.0
0.0
{s}
00
• Selected using TB-A...TB-C
(P2...P2 = 7)
• For S-ramp accel/decel, adjust P0
Deceleration
Time 2
20.0
0.0
{s}
00
Deceleration
Time for Auxiliary
Ramp to Stop
20.0
0.0
{s}
00
• Selected using TB-A...TB-C
(P2...P2 = 9).
• For S-ramp accel/decel, adjust P0
• Once executed, this ramp time has
priority over P05 and P2.
Preset Speed #
0.0
0.0
{Hz}
500
PRESET
SPEED
A
B
C
X
--
--
2
--
X
--
--
--
X
4
X
X
--
5
X
--
X
--
X
X
7
X
X
X
Preset Speed #2
0.0
0.0
{Hz}
500
Preset Speed #
0.0
0.0
{Hz}
500
Preset Speed #4
0.0
0.0
{Hz}
500
Preset Speed #5
0.0
0.0
{Hz}
500
Preset Speed #
0.0
0.0
{Hz}
500
Preset Speed #7
0.0
0.0
{Hz}
500