AC International Lenze SV01B - Manual (Page 31)

ENGLISH 0
Commissioning
Code
Display Range
(READ ONLY)
IMPORTANT
No. Name
Analog Output
0 {VDC} 0.0 See P50…P55
Actual Output
Frequency 0 {Hz} 500.0
Network Speed
Command 0 {Hz} 500.0 Command speed if (Auto: Network) is selected
as the speed source
Terminal and
Protection Status Indicates terminal status using segments of the
LED display. (See section 4.5.7.)
Keypad Status Indicates keypad button status using segments
of the LED display. (See section 4.5.7.2)
Total Run Time 0 {h} 9999999 Alternating display: xxx-; yyyy when value
exceeds 9999
Total Power On
Time 0 {h} 9999999
4.5.7.1 Terminal and Protection Status Display
Parameter P50 allows monitoring of the control terminal
points and common drive conditions:
An illuminated LED segment indicates:
• the protective circuit is active (LED )
• the Logic Assertion Switch is set to High (+)
• input terminal is asserted (LED 2)
• output terminal is energized (LED 4)
• the Charge Relay is not a terminal, this segment will be
illuminated when the Charge Relay is energized (LED 4).
Charge Relay
Input (13C)
Input (13A)
Protection Diagnostic
Current Limit Diagnostic
Logic Assertion Switch
Input (1)
Input (13B)
Relay
Output (14)
4.5.7.2 Keypad Status Display
Parameter P5 allows monitoring of the keypad pushbuttons:
An illuminated LED segment indicates when the button is
depressed.