AC International Lenze SV01B - Manual (Page 21)

ENGLISH 20
Commissioning
Code Possible Settings
IMPORTANT
No. Name Default Selection
Relay Output
TB-, 7 0 0 None Disables the output
 Run Energizes when the drive is running
2 Reverse Energizes when reverse rotation is active
 Fault De-energizes when the drive trips, or
power is removed
4 Inverse Fault Energizes when the drive trips
5 Fault Lockout P0 = ...: De-energizes if all restart
attempts fail
 At Speed Energizes when output frequency =
commanded frequency
7 Above Preset Speed # Energizes when output freq. > P
8 Current Limit Energizes when motor current = P7
9 Follower Loss (4-20 mA) Energizes when 4-20 mA signal falls
below 2 mA
0 Loss of Load Energizes when motor load drops
below P45; see also P4
 Local Keypad Control Active
Energizes when the selected source is
active for start control
2 Terminal Strip Control Active
 Remote Keypad Control Active
4 Network Control Active
5 Standard Reference Active
Energizes when P0 reference is active
 Auto Reference Active Energizes when Auto Reference
is activated using TB- input; see
P2...P2
7 Sleep Mode Active See P240...P242
8 PID Feedback < Min. Alarm Energizes when PID feedback signal
< P24
9 Inverse PID Feedback < Min.
Alarm
De-energizes when PID feedback
signal < P24
20 PID Feedback > Max Alarm Energizes when PID feedback
signal > P25
2 Inverse PID Feedback > Max
Alarm
De-energizes when PID feedback
signal > P25
22 PID Feedback within
Min/Max Alarm range
Energizes when PID feedback signal
is within the Min/Max Alarm range; see
P24, P25
2 PID Feedback outside
Min/Max Alarm range
Energizes when PID feedback signal is
outside the Min/Max Alarm range; see
P24, P25
24 Reserved
25 Network Activated
Requires optional communication
module (refer to the network module
documentation).