AC International Lenze SV01B - Manual (Page 29)

ENGLISH 28
Commissioning
Code Possible Settings
IMPORTANT
No. Name Default Selection
() Motor Stator
Resistance 0.00 0.00 { W} 4.00 • Will be automatically programmed by
P99
• Changing these settings can
adversely affect performance.
Contact factory technical support
prior to changing
() Motor Stator
Inductance 0.0 0.0 {mH} 2000
Torque Limit 00 0 {%} 400 When P00 = 5, sets the maximum
output torque.
Preset Torque
Setpoint # 00 0 {%} 400 TB-A activated; P2 =  and
P00 = 5
Preset Torque
Setpoint #2 00 0 {%} 400 TB-B activated; P22 =  and
P00 = 5
Preset Torque
Setpoint # 00 0 {%} 400 TB-C activated; P2 =  and
P00 = 5
()
Current Loop P
Gain 0.25 0.00 .0
Changing these settings can adversely
affect performance. Contact factory
technical support prior to changing.
() Current Loop I
Gain 5 2 {ms} 9990
() Speed Loop
Adjustment 0.0 0.0 {%} 20.0
Motor Auto-
calibration 0 0 Calibration Not Done • If P00 = 2...5, motor calibration
must be performed, but motor data
must be programmed first
• An alternating / will occur if:
- motor calibration is attempted with
P00 = 0 or 
- motor calibration is attempted
before programming motor data
 Calibration Enabled
2 Calibration Complete
Note
To run the Auto Calibration:
- Set P02...P0 according to motor nameplate
- Set P99 = 
- Make sure motor is cold (20° - 25° C)
- Apply a Start command
- Display will indicate
for about 40 seconds
- Once the calibration is complete, the display will indicate ; apply
another Start command to actually start the motor
- Parameter P99 will now be set to 2.
() Any changes to this parameter will not take effect until the drive is stopped