Goulds Pumps 3296M - IOM User Manual
Page 64
Advertising
3. After the coupling guard half (pump end) is located
around the end plate, secure it with a
3
8
- 16x2"
hex head bolt, nut and two (2) washers through the
round hole at the front end of the guard half as
shown in Figure D. Tighten securely. See detail
drawing, Figure E.
4. Spread bottom of coupling guard half (driver end)
slightly and place over coupling guard half (pump
end) so that annular groove in coupling guard half
(driver end) faces the motor as shown in Figure F.
60
3296 M Group 6/05
Fig. C
Annular
Groove
Coupling
Guard
Half
Pump
End
Plate
Fig. D
Fig. E
Annular Groove
Pump End Plate
Guard Half
Washer
Nut
Bolt
Fig. F
Coupling
Guard
Half
Motor
Advertising