Konica Minolta bizhub 222 - Manual (Page 153)

9 Registering/specifying settings
9-6 362/350/282/250/222/200
Regist
er
ing/
spe
c
if
ying set
ti
ngs
Chapter 9
8
Use the keypad to type
in the telephone number
of the recipient, and then
touch [Next].
– A number up to 64
digits long can be
entered for the tele-
phone number.
– To add a pause of 3
seconds, touch
[Pause]. “P” appears.
When transmitting to
an outside line, touch [Pause] after the outside line access number (for
example, “0”) to ensure that a connection is established.
If a country code and recipient’s fax number is entered immediately af-
ter the international dialing code, a busy signal may heard while the
number is dialed and the fax cannot be sent. In this case, touch
[Pause] twice after entering the international dialing code, and then en-
ter the remainder of the telephone number after the six-second pause.
If the fax still cannot be sent, use the “Quick Scan TX” function.
– To specify that the remainder of the transmission is for pulse dial-
ing, touch [Tone]. “T” appears in the screen. If pulse dialing is being
used, touch this button to send push-button tones.
– S: To perform a checked receiver transmission, touch [S] to type in
the special character “S”. For details on checked receiver transmis-
sions, refer to “Check the recipient before sending” on page 2-28.
– To transmit overseas, touch [Overseas].
When faxing overseas, depending on the destination, a transmis-
sion error may occur if the transmission conditions are poor. In this
case, touch [Overseas] to decrease the transmission speed and al-
low the fax to be received more easily.
– To specify F-codes, touch [F-CODE]. For details, refer to “Register-
ing an F-code” on page 9-8.
– To specify the transmission speed, touch [Speed]. For details, refer
to “Specifying the transmission speed” on page 9-10.