Konica Minolta bizhub 222 - Manual (Page 270)

Utility mode 10
362/350/282/250/222/200 10-87
Utility mode
Chapter 10
Specifying settings for checked receiver transmissions (mode 200)
Specify whether or not the fax transmission is sent after checking the CSI
(called subscriber ID) signal from the recipient’s machine.
Settings at time of purchase
Specifying the setting
During the production of this unit, the settings in the shaded cells were se-
lected.
Bit 7 6 5 4 3 2 1 0
Setting 0 0 0 0 0 1 0 0 (HEX: 04)
Bit Description Setting Description Page Refer-
ence
7, 6, 5 ----------------------- 000 *Do not change these bits
when specifying settings
for this function. ----------
4 Specify whether or
not the machine per-
forms a checked re-
ceiver transmission
if the called number
does not contain
special characters
for a checked re-
ceiver transmission. 0 Does not perform a
checked receiver trans-
mission p. 2-28
1 Performs a checked re-
ceiver transmission
3, 2, 1, 0 Specifies the
number of digits of
the CSI signal that
are compared when
performing a
checked receiver
transmission.
(If the called number
does not fulfill the
number of digits
specified here, a
comparison is made
with all digits of the
called number. If a
comparison is made
with a comparison
number using spe-
cial characters, the
comparison is made
with all digits of the
comparison
number, regardless
of the number of
digits specified with
this setting.) 0000 Cancel p. 2-28
0001 1 digit
0010 2 digits
0011 3 digits
0100 4 digits
0101 5 digits
0110 6 digits
0111 7 digits
1000 8 digits
1001 9 digits
1010 10 digits
1011-1111 *Do not specify these set-
tings for this function.