Tone volume parameters, Memory rx on/off, Tone volume parameters -14 memory rx on/off -14 – Konica Minolta bizhub 222 User Manual
Page 197: P. 10-14
10
Utility mode
10-14
362/350/282/250/222/200
Utility mode
Chapter 10
4
Specify the desired settings, and then touch [Enter].
–
To cancel changes to the settings, touch [Cancel].
2
Note
To exit the User Management screen, touch [Enter] in each screen until
the standby screen appears.
Tone volume parameters
In the User Management screen, sound levels can be specified using the
“Line Monitor Sound” and the “Job Complete Beep” parameters.
Memory RX ON/OFF
Parameter
Description
Default Setting
Line Monitor
Sound
Specify the volume (between 0 and 5) of the sound
produced when a transmission is being monitored.
3
Job Complete
Beep
Specify the volume (between 0 and 5) of the tone pro-
duced when a job is completed.
3
Parameter
Description
Memory RX ON/
OFF
This is a temporary print function that can be used even in the off mode
(setting where printing is not immediate, even when a fax is received). The
print management password is required to print.