Konica Minolta bizhub 222 - Manual (Page 274)

Utility mode 10
362/350/282/250/222/200 10-91
Utility mode
Chapter 10
Specifying whether transmission source information is added when
performing an IP relay operation or forwarding received documents
(mode 352)
Specify how transmission source information is added when performing an
IP relay operation or forwarding received documents.
Settings at time of purchase
Specifying the setting
During the production of this unit, the settings in the shaded cells were se-
lected. The numbers on the right side indicate the page numbers with de-
scriptions for the corresponding function.
5, 4, 3, 2, 1,
0 ----------------------- 101000 *Do not change these bits
when specifying settings
for this function. ---------
Bit Description Setting Description Page Refer-
ence
Bit 7 6 5 4 3 2 1 0
Setting 1 1 0 1 0 0 0 0 (HEX: D0)
Bit Description Setting Description Page Refer-
ence
7 ----------------------- 1 *Do not change this bit
when specifying settings
for this function. ----------
6 Specifies where
transmission source
information is added
with IP relay opera-
tions. 0 Outside of the document ----------
1 Inside the document
5 Specifies whether or
not transmission
source information
is added to received
documents that are
forwarded. 0 Not added p. 10-53
1 Added
4 Specifies where
transmission source
information is added
when a received
document is for-
warded. 0 Outside of the document
1 Inside the document
3, 2, 1, 0 ----------------------- 0000 *Do not change these bits
when specifying settings
for this function. ----------