Konica Minolta bizhub 222 - Manual (Page 278)

Utility mode 10
362/350/282/250/222/200 10-95
Utility mode
Chapter 10
Specifying settings to limit the use of communication modes-2 (mode
476)
Specify whether to permit or prohibit the use of individual communication
modes. Prohibited communication modes do not appear in their selection
screens.
2
Note
Programmed one-touch dial buttons can be used for transmission even
if a prohibited communication mode has been specified.
If all communication modes are prohibited (modes 475 to 477), some
screens, such as those for specifying transmission settings, may not nor-
mally be displayed.
Settings at time of purchase
Specifying the setting
During the production of this unit, the settings in the shaded cells were se-
lected. The numbers on the right side indicate the page numbers with de-
scriptions for the corresponding function.
2 Specifies whether or
not the use of an
FTP server is pro-
hibited. 0 Permitted ----------
1 Prohibited
1 Specifies whether or
not the use of SNMP
is prohibited. 0 Permitted ----------
1 Prohibited
0 ----------------------- 0 *Do not change this bit
when specifying settings
for this function. ----------
Bit Description Setting Description Page Refer-
ence
Bit 7 6 5 4 3 2 1 0
Setting 0 0 0 0 0 0 0 0 (HEX: 00)
Bit Description Setting Description Page Refer-
ence
7 Specifies whether or
not the use of the
Scan to SMB opera-
tion is prohibited. 0 Permitted ----------
1 Prohibited