Konica Minolta bizhub 222 - Manual (Page 72)

Transmission 2
362/350/282/250/222/200 2-29
T
ran
sm
iss
ion
Chapter 2
- By adding a comparison number after the special character, the docu-
ment can be sent only if the comparison number matches the CSI signal.
- The number of digits that are compared in the CSI signal and the recipi-
ent’s telephone number can be specified with the software switch set-
tings. As a factory default, the machine is set to “4 digits”.
!
Detail
For details on transmitting using one-touch dial buttons, refer to “Using
a one-touch dial button” on page 2-19.
For details on programming one-touch dial buttons, refer to “Registering/
specifying settings” on page 9-2.
For details on the software switch settings for checked receiver transmis-
sions and the number of digits that are compared, refer to “Specifying
software switch settings (machine functions)” on page 10-67.
To perform a check receiver transmission
1
Press the [Fax/Scan] key to display the Fax mode screen.
2
Position the document to be faxed.
3
Touch [Direct Input].
Dialing method Method for checking the recipient’s ma-
chine
Recipient’s telephone number + special char-
acter “S” The CSI signal and recipient’s telephone
number are compared.
Recipient’s telephone number + special char-
acter “S” + comparison number The CSI signal and comparison number are
compared.