Olympus E-330 - Manual (Page 109)

109
Other function settings
Cu
stomizing th
e settings/functio
ns of
your
came
ra
7
ISO limit
This allows you to set the maximum ISO. Even if the ISO value is fixed in ISO
setting, it does not become more than the maximum ISO set in [ISO LIMIT].
MENU[Y][ISO LIMIT]
[OFF]/[100]/[200]/[400]/[800]
Compensating all WB
This lets you apply the same compensation value to all the white balance
modes at once.
MENU[Y][ALL>]
[ALL SET] The same compensation value applies to all WB modes.
[ALL RESET] The WB compensation value settings applied to each WB
mode are all cleared at once.
If you select [ALL SET]
1) Use bd to select the color direction.
R-B Red kBlue/G-M GreenkMagenta
2) Use ac to set compensate value. “WB Compensation” (g P. 84)
• You can check the white balance you have adjusted.
If you select [ALL RESET]
1) Use
ac to select [YES].
Manual flash
This allows the built-in flash to output a fixed amount of light. With [MANUAL
FLASH] set to [ON], you can set the amount of light (FULL, 1/4, 1/16, or 1/64)
in the flash mode setting.
MENU[Y][MANUAL FLASH]
[ON]/[OFF]
Speed synchronization
You can set the shutter speed that will be used when the built-in flash fires.
The speed can be set from 1/60 to 1/180 in 1/3 EV increments.
MENU[Y][#X-SYNC]
[1/60]/[1/180]
• For details on the synchronization speed of commercially available flashes,
refer to their manuals.
s0003_e_advanced.book Page 109 Tuesday, December 27, 2005 1:36 AM