En g lis h, Bbc c – Toshiba L6463 User Manual
Page 18
18
En
g
lis
h
SETTING UP YOUR TV
To save your setting, press the GREEN button.
This item is greyed out when Encryption is None.
When Encryption is WEP, Key ID setting is
available. Press
B
/
b
to select Key ID and press
c
and
B
/
b
to select 1 (default), 2, 3 or 4.
Press
B
/
b
to highlight Done and press OK.
When the message “Wireless configuration is
complete.” appears on screen, press OK.
NOTE: Settings are not saved if BACK is pressed
before Done is selected.
n
The Advanced Network Setup screen will
appear.
When the DHCP function of the router connected
with this TV is On, you can set Auto Setup to On
or Off. (This should usually be set to On.)
When the DHCP function of the router is Off, set
Auto Setup to Off, and set the IP Address DNS
address(es) manually.
You can view the fixed MAC address for the TV, if
one is installed.
Press
B
/
b
to highlight Next.
o
Press OK, and Network Connection Test will start.
A message will appear to indicate if the connection
was successful or if could not be completed.
NOTE: The result of Network Connection Test
does not always guarantee the connection.
To cancel the Network Connection Test:
Press EXIT while testing.
When the network can be accessed, Software
Upgrade starts automatically. When Software
Upgrade is completed, proceed to the next step.
p
Press OK, and Power Management screen will
appear. Press
B
/
b
to highlight the External
Record Control. Press
c
and
B
/
b
to select Off
or On and press OK.
q
Press
B
/
b
to highlight the Companion Device
Control. Press
c
and
B
/
b
to select Off or On
and highlight Next.
r
Press OK. If the Ant/Cable/Satellite screen
appears, press
B
/
b
to select Antenna, Cable or
Satellite, and then press OK to check (
).
• When you select Antenna or Cable, follow step
19 to 22.
• When you select Satellite, skip to step 23.
• When you select Antenna (or Cable) and
Satellite, the Satellite Settings startup screen
will appear automatically after completing the
Antenna (or Cable) scan and pressing OK.
s
Press
BbC c
to highlight Next and press OK.
The Auto Tuning start up screen will appear with
the option to select between DTV and ATV, DTV
or ATV if available. Press
c
and
B
/
b
to select
the appropriate mode and press OK.
T
Press
b
to highlight Start Scan, and press OK.
The television will start to search for available DTV
and/or ATV channels. The progress bar will
indicate the scan status.
You must allow the television to complete the
search.
When the search is complete, the television will
automatically select channel one.
The Auto Tuning screen will display the total
number of services found.
u
Press
C
/
c
to view the DTV (digital channel) or
ATV (analogue channel) lists.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
xxx xxx xx x
xxx xxx xx x
xxx xxx xx x
xxx xxx xx x
xxx xxx xx x
Quick Setup
Country
Location
Network
Smart TV
Channel Tuning
Advanced Network Setup
3/5
Previous
Next
Auto Setup
IP Address
Subnet Mask
Default Gateway
Auto Setup
Primary DNS Address
Secondary DNS Address
On
On
OK
5/5
Network Connection Test
Network connection was completed successfully.
Antenna
Cable
Satellite
Previous
Next
Auto Tuning - Antenna
Channel: 23
Progress
0
0
DTV Tune
ATV Tune
4 %
Waiting...
Found