Ant/cable/satellite (if available) – Toshiba L6463 User Manual
SETTING UP YOUR TV
From this menu, you can set the RF input configuration.
to highlight Installation
to select Channel Tuning and
to select Ant/Cable/Satellite and
to select Antenna, Cable or
to highlight Next and press OK.
NOTE: When you attempt to change the Ant/
Cable/Satellite setting, a warning message will
appear followed by PIN entry (if PIN has been set)
and a prompt for Auto Tuning.
When Ant/Cable/Satellite is set to Cable, the
following setting options will be provided in the
Auto Tuning screen.
to select an item and press
to select your desired option.
With the exception of DTV Scan Type and DTV
Modulation items, all of the following items will have 2
operating modes. The first is Auto where the values for
each item are preset by the system. The second is an
Input mode where you will be able to enter a single value
in place of the pre-set value. If no channel is currently
tuned and the Input state is chosen, a system default
value will be shown. However, if a channel is currently
tuned when the item is accessed, the value of the current
channel will be displayed.
You can choose the Cable operator depending on the
Country you set.
DTV Scan Type:
This item determines whether a Quick Scan or a Full
Scan will be executed.
The Quick Scan is a simplified version of the Full Scan
that is designed to complete in less time.
DTV Start Frequency:
This sets the frequency from which the scan will begin.
DTV End Frequency:
This sets the frequency at which the scan will end.
You can choose from six QAM modulation settings.
DTV Symbol Rate:
This is the baud rate (KS/s) of the scan.
DTV Network ID:
This is the Network ID to be utilized for the scan. This item
is greyed out when DTV Scan Type is set to “Full Scan”.
Ant/Cable/Satellite (if available)
DTV and ATV
Auto Tuning - Cable