Sharp MX-2614N - Manual (Page 298)

3-33
PRINTER
Contents
STAPLING OUTPUT/PUNCHING HOLES IN
OUTPUT
Staple function
The staple function can be used to staple output.
This function saves considerable time when preparing handouts for a meeting or other stapled materials. The staple
function can also be used in combination with two-sided printing to create materials with a more sophisticated appearance.
Stapling positions and the number of staples can be selected to obtain the following stapling results.
* The staple orientation varies depending on the size and orientation of the paper.
Punch function
The punch function can be selected to punch holes in printed output. Punch hole positions can be set by selecting the
binding edge.
Staples Left Right Top
1 Staple*
2 Staples
Left Right Top
• To use the staple function, a finisher is required.
• To use the punch function, a punch module must be installed on the finisher.
• The number of holes that can be punched and the spacing between the holes varies depending on the installed punch module.
• For the maximum number of sheets that can be stapled, see "SPECIFICATIONS" in the Start Guide.
The maximum number of sheets that can be stapled at once includes any covers and/or inserts that are inserted.
• The staple function cannot be used in combination with the offset function, which offsets the position of each output job
from the previous job.
• When the finisher is disabled in the machine's system settings (administrator), the staple function and punch function
cannot be used.
• When the staple function or the punch function is disabled in the machine's system settings (administrator), stapling or
punching is not possible.