Sharp MX-2614N - Manual (Page 98)

1-57
BEFORE USING THE MACHINE
Contents
CLEANING THE PT CHARGER OF THE PRIMARY
TRANSFER BELT
If black lines or coloured lines appear even after you have cleaned the document glass, automatic document feeder and
the main charger, use the PT charger cleaner to clean the PT charger.
1
Open the front cover.
2
Release the lock of the waste toner box.
Move the lock of the waste toner box to the release position.
Release the lock of the waste toner box and let it fall forward as
far as it will go as shown in the figure.
3
Remove the waste toner box.
Hold the box by both hands and lift it up slowly.
If the waste toner box falls too far forward, it will not be possible
to remove it. (Remove the box when it is at an angle of about
30 degrees.)
4
Clean the PT charger
(1) Slowly pull out the PT charger cleaner till a
point where it offers resistance.
(2) Slowly push the PT charger cleaner back till
the end.
(3) Repeat the steps (1) and (2) three times.