Hale Q Series Muscle - Manual (Page 152)

 Gearbox Maintenance
152 MUSCLE (Midship) Pumps Installation, Operation, and Maintenance Manual
p/n: 029-0020-63-0
Figure 9-3: Power Gearshift Assembly
8. Clean and inspect all parts for excessive wear, chips, scoring or other damage.
Repair and/or replace accordingly.
Sliding Gear and Fork
(See Figure 9-1: “Intermediate Shaft and Sliding Gear, Typical G Series Gearbox” on
page 149.)
Note: If your assembly includes the PTO drive option, first remove the PTO drive to enable
disassembly the sliding gear and fork. See heading “PTO Drive Option, Qflo / Qflo Plus /
Qpak Series Pump” on page 153.
1. If the tail shaft has not been removed, set the gear shift to the ROAD position to
place the sliding gear on the tail shaft.
If the tail shaft has been removed, leave the gearshift in the PUMP position.
2. If the optional speed counter is included, disconnect the electrical connector and
unscrew the sensor from the front bearing cap.
3. Remove the front bearing cap and gasket - four 7/16”-14 screws.
4. Remove the sliding gear assembly from the housing.
5. If the tail shaft is not removed, remove the front sliding gear assembly from the
gearbox housing. Reach in and slide the sliding gear from the tail shaft.