Hale Q Series Muscle - Manual (Page 154)

 Gearbox Maintenance
154 MUSCLE (Midship) Pumps Installation, Operation, and Maintenance Manual
p/n: 029-0020-63-0
Figure 9-4: PTO Drive Option
Assembly
Gearshift Cap
(See Figure 9-3: “Power Gearshift Assembly” on page 152.)
1. Install new switch seal rings, then thread gearshift switch into the gear shift shaft
cap.
2. Install a new gearshift cap gasket.
3. Install the gearshift shaft cap - two 7/16”-14 screws.
Sliding Gear Assembly
(See Figure 9-1: “Intermediate Shaft and Sliding Gear, Typical G Series Gearbox” on
page 149.)
1. Hold the gearshift fork in place and slide the gearshift shaft through the opening
in front of the housing and the gearshift fork. Be sure the fork is in the proper
position.