Hale Q Series Muscle User Manual

Page 96

Advertising
background image

Troubleshooting

96

MUSCLE (Midship) Pumps Installation, Operation, and Maintenance Manual

p/n: 029-0020-63-0

Insufficient Pump
Capacity, Single
Stage.

Insufficient engine
power.

• Engine power check and tune up may be required for peak engine

and pump performance.

• Also see heading “Rotation Symptoms.” on page 101.

• Recheck pumping procedure for recommended transmission gear

or range. Use mechanical speed counter on pump panel to check
actual speed against possible clutch or transmission slippage or
inaccurate tachometer.

• Check truck manual for proper speed counter ratio.

Relief valve improp-
erly set - if so
equipped.

• If relief valve pressure is set too low it allows the valve to open

and bypass water.

• Reset the relief valve pressure accordingly.

• See Section 4 Preventive Maintenance, heading “Relief Valve and

TPM Test” on page 73.

Suction hose diame-
ter is too small for the
volume being dis-
charged

• Use larger sustain hose.

• Shorten total length by remove one length at a time.

• Reduce volume of discharge.

Restriction in suction
line at strainer

• Remove any debris restricting entrance of water at the strainer.

• See Section 4 Preventive Maintenance, heading “Intake Strain-

ers” on page 75.

Air leaks

• See heading “Air leaks” under condition “ Pump Loses Prime or

WIll Not Prime” on page 95.

Partial collapse of the
lining in the suction
hose

• Damage to the outer lining may allow air between the outer and

inner linings causing a partial collapse.

• Replace hose and retest.

Engine governor set
incorrectly.

• If the engine governor is set too LOW (pressure), when on auto-

matic, engine speed decelerates before the desired pressure is
achieved.

• Reset governor per manufacturer’s procedures.

Truck transmission in
wrong gear or clutch is
slipping.

• Recheck the pumping procedures for the recommended transmis-

sion or gear range. Also see Section 3 Operation, heading “Basic
Operation” on page 53.

• Use a mechanical speed counter on the pump panel to check

speed against possible clutch or transmission slippage or inaccu-
rate tachometer.

• Check truck manual for proper speed counter ration.

Table 6-1: Muscle (Midship) Pump Troubleshooting (Sheet 4 of 9)

Condition

Possible Cause

Suggested Corrective Action

Advertising
This manual is related to the following products:

8FG