Hale Q Series Muscle User Manual
Page 70
Basic Operation
70
MUSCLE (Midship) Pumps Installation, Operation, and Maintenance Manual
p/n: 029-0020-63-0
Open the pump body drain cocks or Hale multiple drain valve. If a multiple
drain valve is used, all pump drain lines should be connected to this valve.
On two-stage pumps, move the transfer valve back and fourth between the
VOLUME and PRESSURE positions.
4.
If sea water, dirty water, alkaline water or foam solution has been used, FLUSH
THE PUMP WITH CLEAN WATER.
5.
If installed, drain the gearbox cooler. After the pump is completely drained,
replace all caps and close all valves.
6.
Remove the wheel chocks only when preparing to leave the scene.
7.
Fill out the Pump Run Log, indicating total pumping and out-of-station time.
8.
Report all pump, vehicle and equipment malfunctions, and irregularities to the
proper authority.
9.
Know and follow all local procedures. See WARNING! note on page 53.