Hale Q Series Muscle - Manual (Page 168)

 Gearbox Maintenance
168 MUSCLE (Midship) Pumps Installation, Operation, and Maintenance Manual
p/n: 029-0020-63-0
9. Remove and check bushing for wear. Replace accordingly with Hale p/n: 250-
9550-00-0.
Installation
1. Install new seal ring in cylinder groove.
2. Using a light coating of general-purpose grease to hold it in place, install gasket
on gearbox.
3. Align KPS cylinder and secure using two 7/16-14 x 1” screws.
4. Apply a light coating of general-purpose grease to seal rings before installation.
Install a new seal ring on the piston then install piston on shaft. Make sure the flat
side of the piston is towards the inside of the cylinder.
5. Thread extension shaft onto shift rod. Prior to installation, coat threads with Loc-
tite 246 (or equal).
6. Make sure the piston and shaft move freely in the shift cylinder.
7. Apply a light coating of general-purpose grease then install the scraper and seal
rings in the KPS cover.
8. Install KPS cover with scraper and seal rings over the shaft.
9. Apply Loctite 246 (or equal) then install four 5/16-18 x 1” screws.
10. Install rod end and 3/8-16 nut on end of shift shaft. Lock the rod end with the nut.