Apple Final Cut Pro 6 - Manual (Page 205)

204 Part III Setting Up Your Editing System
To choose a device control preset in the Log and Capture window:
1 Choose File > Log and Capture, then click the Capture Settings tab.
2 From the Device Control pop-up menu, choose a device control preset that
corresponds to your connected device.
For an explanation of each device control preset, see Volume IV, Chapter 26, “Device
Control Settings and Presets.”
To choose a device control preset in the Audio/Video Settings window:
1 Choose Final Cut Pro > Audio/Video Settings.
2 Do one of the following:
 In the Summary tab, choose a device control preset from the Device Control Preset
pop-up menu.
 In the Device Control Presets tab, click in the column to the left of the device control
preset you want to select.
3 Click OK.
Because an Easy Setup contains a device control preset, you can also change the device
control preset by changing the Easy Setup. However, this may also change the capture
and sequence presets.
Understanding Device Control Status Messages
At the bottom of the Log and Capture window, the device status area shows the
readiness of camcorders and decks being controlled by Final Cut Pro.
The device status area can display any of these messages:
 VTR OK: This indicates your equipment is connected and working properly.
 No Communication: This indicates one of the following:
 Final Cut Pro has not established communication with your deck or camcorder.
 Your VTR or camcorder is a non-controllable device, so it has no ability to be
remotely controlled.
If you have a device-controllable camcorder or deck and you see this status, check to
make sure that you’re using the right FireWire or serial control cables and that they’re
connected properly. Also make sure your device is turned on.
Device status