Apple Motion 3 - Manual (Page 1046)

1046 Chapter 12 Using Shapes and Masks
 Over Fill: Outlines appear on top of the selected fill of the shape.
 Under Fill: Outlines are obscured beneath the selected fill of the shape.
Solid Brush Additional Parameters
The following parameters are available when Solid is the selected Brush Type.
Preserve Width: When this checkbox is selected, the defined width of the outline/
stroke does not change when the shape is scaled. This option is only available when
Solid is the selected Brush Type.
Joint: When Solid is the selected Brush Type, this pop-up menu lets you choose how
hard corners on a shape’s outline are drawn. There are three options:
 Square: All corners are squared off.
 Round: All corners are rounded.
 Bevel: All corners are cut at an angle.
Start Cap: A pop-up menu that lets you choose the shape of an outline’s start cap. This
option is only available when Solid is the selected Brush Type.
End Cap: A pop-up menu that lets you choose the shape of an outline’s end cap. This
option is only available when Solid is the selected Brush Type.
Over Fill Under Fill
Round joints Beveled joints