Apple Motion 3 - Manual (Page 913)

Chapter 10 Using Filters 913
This filter causes rasterization in 3D groups.
Parameters in the Inspector
Amplitude: Sets the amplitude of the waves. Values range from 0 to 100.
Wavelength: Sets the length of the waves. Values range from 1 to 100.
Offset: Sets the offset of the wave, with values ranging from –500 to 500.
Vertical: Toggles whether the waves run vertically or horizontally.
Repeat Edges: Toggles whether or not the edges of the object are repeated.
Mix: Sets what percentage of the original image is blended with the filtered image.
Values range from 0 to 100%.
HUD Controls
The HUD contains the Amplitude, Wavelength, Offset, and Vertical controls.
Glow Filters
Glow filters combine blur with brightness and color effects. The results are
automatically recomposited over the original image in many different ways. Glows can
be used to simulate film effects, as a method to make your footage more abstract, or
used more subtly, as accents to make individual elements in a composition stand out.
Original image Wave filter applied