Apple Motion 3 - Manual (Page 909)

Chapter 10 Using Filters 909
Parameters in the Inspector
Center: Sets the position of the center of the starburst.
Radius: Sets the radius of pixel sampling for ray color determination. Values range from
0.01 to 200.
HUD Controls
The HUD contains the Radius control.
Stripes
By default, this filter turns your object into a series of vertical stripes. The angle of
generated stripes can be changed using the Angle parameter. The stripe colors are
derived from pixel values along a line through the center point at the angle specified
by the Angle parameter. The distribution of colors is determined by the Offset
parameter.
This filter causes rasterization in 3D groups.
Parameters in the Inspector
Center: Sets the position of the center of the stripe effect.
Angle: Sets the angle of the stripes.
Offset: Sets the angle of pixel sampling used for sampling pixel color values.
Mix: Sets what percentage of the original image is blended with the filtered image.
Values range from 0 to 100%.
HUD Controls
The HUD contains the Angle and Offset controls.
Original image Stripes applied