Snap rings and screws, Snap rings and screws -44 – JLG 1100S Service Manual User Manual
Page 192
Advertising
SECTION 4 - BOOM & PLATFORM
4-44
– JLG Lift –
3121256
4. Hold the flat bar and remove the screws.
5. Remove the snap rings and pins.
6. Remove the screws from the bar. Remove the snap
ring and pin.
7. Slide the link out.
Snap Rings and Screws
WHEN PERFORMING MAINTENANCE ON THE POWERTRACK,
MAKE SURE TO DISCARD AND REPLACE ALL OLD SCREWS.
Make sure screws are tight and installed properly.
LOOSE SCREW
TIGHT SCREW
Advertising
This manual is related to the following products: