Boom sensor calibration position 8 -75 – JLG 1100S Service Manual User Manual
Page 349
Advertising
SECTION 6 - JLG CONTROL SYSTEM
3121256
– JLG Lift –
6-75
When Position 7 Calibrating is complete, the screen
will read:
Press Enter. The screen will read:
30. Lift until the function stops (controller will stop at 5
degrees above horizontal) for Calibration Position 8.
When the machine is in the proper position, hit
Enter. The screen will read:
Figure 6-21. Boom Sensor Calibration Position 8
Advertising
This manual is related to the following products: