JLG 1100S Service Manual - Manual (Page 351)

SECTION 6 - JLG CONTROL SYSTEM
3121256 – JLG Lift – 6-77
Press Enter. The screen will read:
32. Telescope in to green witness mark (controller will
find the position - operator must visually verify the
position).
When the boom is in the proper position, the screen
will read:
Press Enter. The screen will read:
33. After completing all the Boom Sensors Calibrations,
hit ESC twice to go back to Calibrations.
34. Cycle the emergency stop switch.
Figure 6-23. Boom Sensor Calibration Position 10