JLG 1100S Service Manual - Manual (Page 79)

SECTION 3 - CHASSIS & TURNTABLE
3121256 – JLG Lift – 3-37
the spindle pins. Lock with a ÿ40 outer snap ring.
Lubricate the bearings.
14. Using a marking pen, make a mark between the
snap ring and the bearing. Fit the greased spring
and the release joint. Use grease to fit the O-Ring 2-
275 in the hub support seat.
15. Place the hub onto the support making the two
holes coincide for tightening the M10x25 flathead
socket screws at the torque of 5daNm.
16. Fit the reduction gears and the pinion in the unit.
17. Prepare the closing cover fitting the O-ring 5-582
suitably greased and lock it with the shimming ring.
Lubricate the bearings.