16 swing drive lubrication, Swing drive lubrication -71, Swing drive ports -71 – JLG 1100S Service Manual User Manual
Page 113
Advertising
SECTION 3 - CHASSIS & TURNTABLE
3121256
– JLG Lift –
3-71
5. Pre-torque the capscrews (shown below) to 90 foot-
pounds (122 Nm) with Loctite #271.
6. Tighten the setscrew (shown below) until the pinion
is completely snug against the shim and bearing
and then back off the setscrew.
7. Torque the setscrew to 50 foot-pounds (68 Nm).
8. Tighten the jam nut (shown below) with Loctite
#271.
9. Torque the capscrews shown in step 5 to 660 foot-
pounds (896 Nm).
10. Remove shim and discard.
3.16 SWING DRIVE LUBRICATION
1
2
3
4
Brake Bleed Port
Brake Fill Port
Gearbox Fill Port
Gearbox Drain Port
Figure 3-46. Swing Drive Ports
Advertising
This manual is related to the following products: