JLG 1100S Service Manual - Manual (Page 300)

SECTION 6 - JLG CONTROL SYSTEM
6-26 – JLG Lift – 3121256
6.10 MACHINE ORIENTATION WHEN SETTING
FUNCTION SPEEDS
Lift Up: From platform control, lowest elevation up to max-
imum elevation, boom retracted.
Lift Down: From platform control, maximum elevation
down to minimum elevation, boom retracted.
Swing Right (Max): 360 Degrees, from platform control,
boom approximately 45° elevation, boom retracted.
Swing Left (Max): 360 Degrees, from platform control,
boom approximately 45° elevation, boom retracted.
Telescope Out: From platform control, boom horizontal,
500 lb. (230 kg) capacity selected (1100SJP Only).
Telescope In: From platform control, boom horizontal,
500 lb. (230 kg) capacity selected (1100SJP Only).
Drive Forward (Max): Test should be done on a smooth
level surface. High Speed - Low Torque setting, drive 200
ft. (61 m) front wheels to front wheels. Timed after
machine has obtained maximum speed.
Drive Reverse (Max): Test should be done on a smooth
level surface. High Speed - Low Torque setting, drive 200
ft. (61 m) front wheels to front wheels. Timed after
machine has obtained maximum speed.
Drive Forward (Creep Max): Test should be done on a
smooth level surface. High Torque - Low Speed setting,
platform speed knob at full creep.
Drive Reverse (Creep Max): Test should be done on a
smooth level surface. High Torque - Low Speed setting,
platform speed knob at full creep.
Drive Forward (Elevated Max - Boom Beyond Trans-
port): Test should be done on a smooth level surface.
High speed - Low Torque setting, platform speed knob out
of creep, Lift boom above transport, drive forward 50 ft.
(15.2 m).
Drive Reverse (Elevated Max - Boom Beyond Trans-
port): Test should be done on a smooth level surface.
High speed - Low Torque setting, platform speed knob out
of creep, Lift boom above transport, drive forward 50 ft.
(15.2 m).
Platform Rotate: Platform level and completely rotated
one direction. Rotate the opposite direction, Record Time.
Rotate the other direction, Record Time.
Articulating Jib: Platform level and centered with the
boom. Start with the Jib down. Jib Up, Record Time. Jib
Down, Record Time.
Test Notes
1. Personality settings can be adjusted anywhere
within the adjustment range in order to achieve opti-
mum machine performance.
2. Stop watch should be started when the function is
activated.
3. Unless noted, all speed tests are run from the plat-
form. These speeds do not reflect the ground con-
trol operation.
4. The platform speed knob control must be at full
speed (turned clockwise completely).
5. Function speeds may vary due to cold, thick hydrau-
lic oil. Test should be run with the oil temperature
above 100° F (38° C).