JLG 1100S Service Manual - Manual (Page 76)

SECTION 3 - CHASSIS & TURNTABLE
3-34 – JLG Lift – 3121256
12. Disassemble the Ø160 inner snap ring and pull the
spring holder spacer out. Remove the springs and
using a compressed air jet in the brake control hole
pull the piston out of the spindle.
13. Remove the brake discs and seals.
14. Fit the ball bearing into the input shaft and lock it
with a Ø40 outer snap ring. Then mount the motor
shaft in the spindle and lock with a BR68 ring. Lubri-
cate the bearing.
Assembly
1. Make sure all the component parts of the wheel gear
are devoid of burrs, machining residues and that
they are correctly washed.
2. Fit the ball bearing in the input shaft and lock with a
Ø40 outer snap ring.
3. Mount the motor shaft in the spindle and lock with
BR68 ring. Lubricate the bearing.