JLG X500AJ Operator Manual - Manual (Page 101)

SECTION 5 - EMERGENCY PROCEDURES
3121636 – JLG Lift – 5-13
5.4 SAFETY DEVICES BYPASS KEY USE
THIS FEATURE MUST ONLY BE USED AS DESCRIBED BELOW. THE
MACHINE COULD TIP OVER IF THESE DIRECTIONS ARE NOT FOLLOWED.
The machine requires a key for bypassing the platform
safety systems. To activate the safety device bypass switch
(item 2 - photo), locate the key set. From the factory the key
set is fastened to the cover screw mounting tab (item 1 -
photo) on the left side of the electrical components com-
partment on the right side of the machine.
Remove the key and insert it into the bypass key
switch (item 2 - photo).
• Turn the key to the LEFT for boom operations.
• Turn the key to the right for TRACK operations.
After using the safety device bypass, a qualified JLG
mechanic must be contacted to determine the reason
required to use this feature.
Return the key to the where you found it and secure it in that
location.
The safety device circuit board records every time the safety
device bypass key is activated along with the movements
made during these operations.
THE SAFETY DEVICE BYPASS ALLOWS OPERATION OF THE MACHINE
WITH AN OVERLOAD IN THE PLATFORM. THE OVERLOAD ALARM WILL
SOUND AND THE OVERLOAD ICON WILL BE ON THE PLATFORM/REMOTE
CONTROL BOX DISPLAY. REMOVE THE OVERLOAD FROM THE PLATFORM
BEFORE OPERATION.
1
2