JLG X500AJ Operator Manual User Manual
Page 72
SECTION 4 - MACHINE OPERATION
4-22
– JLG Lift –
3121636
THE BATTERY CHARGER SUPPLIED WITH THE LIFT WAS DESIGNED TO
ENSURE SAFE AND RELIABLE PERFORMANCE. IT IS ALREADY FITTED ON
THE MACHINE AND DOES NOT NEED ANY ADJUSTMENT OR CONFIGURA-
TION BY THE USER; NONETHELESS, TO AVOID INJURY AND DAMAGE TO
THE BATTERY CHARGER, THE FOLLOWING ESSENTIAL PRECAUTIONS
MUST BE OBSERVED:
• Carefully read the installation instructions contained in
this manual. For future reference, keep the manual in a
safe place.
• Do not place the battery charger near sources of heat.
• As the battery charger is sealed and without forced ven-
tilation, its performance depends on the ambient tem-
perature and the type of installation.
• Be certain the type of power supply available corre-
sponds to the voltage specified and indicated on the
battery charger rating plate or in this Operation/Mainte-
nance Manual. If any questions, contact your local JLG
Service Center or the local electrical company.
• An AC class circuit breaker can be used as protection
device for the battery charger power supply, however it
is recommended to use a class A or even better class B
device.
• In regard to safety and electromagnetic compatibility,
the battery charger features a three pin plug with
ground, which can only be plugged into an grounded
socket. If the plug does not go into the socket, most
probably the socket is old and not grounded. In this
1
2