JLG X500AJ Operator Manual - Manual (Page 122)

SECTION 6 - GENERAL SPECIFICATIONS AND OPERATOR MAINTENANCE
6-12 – JLG Lift – 3121636
Hydraulic Oil Filter Cartridge
Lube Point(s) - Filter Cap (Indicator A)
Interval - Replace after first 50 hours of use. Replace thereaf-
ter every 250 hours and every time the hydraulic oil is
replaced.
Rubber Track Maintenance/Replacement
Check track tension
Stop the machine on a firm, level, and uniform surface. Raise
the machine off the surface using the outriggers. Measure
distance A from the bottom of the roller to the inside of the
rubber belt. The rubber track tension is to be between
0.4inches (10mm) and 0.6 inches (15mm).
NOTE: If the track is out of tolerance immediately discontinue
use of the machine
THE GREASE CONTAINED WITHIN THE HYDRAULIC TRACK IS PRESSUR-
IZED. NEVER LOOSEN GREASING VALVE 1 MORE THAN ONE (1) TURN.
NEVER LOOSEN GREASE VALVE 2.
A
A