JLG X500AJ Operator Manual - Manual (Page 42)

SECTION 3 - MACHINE CONTROLS, INDICATORS AND OPERATION
3-8 – JLG Lift – 3121636
8. Override/Selector
If the machine is driven into a tilt condition, this
button may be pressed to override the drive cut-
out. Each press of the button will allow the drive
function to operate for approximately 8 seconds to
back the machine from the tilt condition.
This button is also used for selecting an item when
in the Service Menu (item 6).
9. Track Width Adjust
This control allows the operator to narrow the
track.
10. Power/Emergency Stop
A two-position red switch supplies power to PLAT-
FORM Controls when turned counterclockwise
(on). When pushed in (off ), power is shut off to the
platform and ground controls.
11. Gas Engine Starter
This button allows the operator to start or stop the
gas engine.
12. Electric Engine Start
This button allows the operator to start or stop the
electric engine.
13. Platform Level Key Switch
The control allows the operator to adjust the level
of the platform up or down.
14. Display
The display shows the status of the machine and
operating information. Wait until a display screen
appears before beginning operation.
NOTE: Controllers (16 through 23), the speed of component
movement is proportional to the controller distance
from the center neutral position.
The movement of a controller without first
pressing the platform footswitch is indicated
by the depress footswitch error icon on the
platform/remote LCD display.