JLG X500AJ Operator Manual - Manual (Page 63)

SECTION 4 - MACHINE OPERATION
3121636 – JLG Lift – 4-13
Setting Outriggers From the Platform/Remote Console
(Reference Figure 4-4. for item numbers)
Either - Press and hold the outrigger auto-
set and level button 7 (item 7) until OK
appears on the platform LCD display.
or
Operate each outrigger separately by
pressing button 2 (item 2) to select which
outrigger to control (each outrigger is num-
bered 1 thru 4, see decal, each press of but-
ton 2 displays the outrigger selected on the
LCD display). Press button 1 (item 1) to
retract or button 7 (item 7) to set that out-
rigger. The OK will appear on the display
when the outriggers are set properly and
the unit is level.
Note: To cycle back to outrigger auto-set
mode, press button 2 (item 2) until the LCD
display shows the normal operating icons.
CHECK THE BUBBLE LEVEL TO CONFIRM UNIT IS LEVEL (BUBBLE IS COM-
PLETELY IN THE 1° GREEN
(CENTER) AREA) AND THAT THE TRACKS ARE
OFF THE GROUND BEFORE OPERATING THE BOOM FUNCTIONS. IF THE
BUBBLE IN THE LEVEL IS NOT IN THE GREEN AREA, AFTER USING THE
AUTO-LEVEL FUNCTION, SHUT DOWN THE MACHINE AND HAVE THE
MACHINE REPAIRED BY A QUALIFIED SERVICE TECHNICIAN.
Each outrigger has a yellow light installed. All lights will be
on steady if the outriggers are positioned to the full opera-
tion area. No lights will be on if the outriggers are not set
properly.
AUTO
7
MANUAL
SELECT
2