JLG X500AJ Operator Manual - Manual (Page 77)

SECTION 4 - MACHINE OPERATION
3121636 – JLG Lift – 4-27
Loading and Unloading the Machine on Transport
Vehicles Using Ramps
The JLG platform offers high maneuverability and stability
even in travelling (stowed) configuration.
Despite this, the operator is to take safety measures even
when carrying out the simplest operations.
ALWAYS LOAD/UNLOAD THE MACHINE WITH UNDERCARRIAGE
(TRACKS)
EXTENDED TO WIDEST WIDTH.
Loading
For example, follow the procedure below to load the
machine onto a truck/trailer:
• It is recommended to load/unload the machine using
the remote control while keeping away from the
machine, keeping a MINIMUM distance of 3 feet (1m).
• Park the truck/trailer on a flat surface;
• Make sure that the ramps do not exceed the maximum
inclination of 15°;
• Make sure that the ramps and the trailer have the capac-
ity to support the machine and are free from debris or
slippery material;
• Position the ramps parallel to each other at a distance
equal to the space between the tracks;
• Climb the ramps, proceeding with the basket facing
backwards;
• When approaching the loading surface, before the
change in inclination, ALWAYS check that the JIB arm is
COMPLETELY RETRACTED. Then proceed with great care
in order to prevent sudden jolts when passing from the
sloping ramps to the truck/trailer flatbed;
• Position the machine so that none of its parts protrude
from the transport vehicle.
UnLoading
Unload the machine following the same instructions given
above.
• During travel and when changing slope, make sure not
to damage the safety devices positioned under the bas-
ket.
• If the change in inclination is excessive, adjust the angle
of the ramps or, if this is not possible, use longer ramps.
It is also possible to use the jib arm as described earlier.